Dirty Dingo Motorsports is the leading manufacturer in GM LS conversion engine mounts for Chevrolet and GMC trucks and muscle cars. These Patented Design motor mounts are used when installing the 1997-2013 Gen III/IV LS series engine into older GM muscle cars, trucks and any application that uses a standard three bolt factory style engine mount from 1958 to 1972, and Corvette 1962 to 1991(Corvette 1958 to 1961 will require a frame stand to use a GM three bolt mount). Dingo Sliders give up to 2 inches of adjustment, and positions the LS engine ¼” higher than other adapter plates. You can use your factory rubber engine mount, any aftermarket urethane or solid engine mounts. These mounts will also work if you have a clam shell on the block and the engine mount on the frame. Simply bolt your clam shell to the outer plate and install. Precision CNC laser cut from .250 cold roll plate steel. Dingo Sliders will allow you to mount the engine in the original bell housing position, or move the engine forward up to 2 inches. May require using aftermarket oil pan. These mounts are sold in pairs. "D" is marked for Driver's side, "P" is marked for Passenger side. These mounts will not clear low mount a/c or low mount GTO rear alternator brace, but they will clear Camaro low mount alternators with limited movement. Will not fit on 1967-72 4X4 Chevrolet GMC trucks. Steel.
WARNING Cancer and Reproductive Harm: https://www.p65warnings.ca.gov/